Inspection vs. Testing

Airborne Environmental provides two services;

1. Inspections
2. Testing.

Though it is not always necessary to do both, it is usually recommended for the following reasons:

1. In some cases, an air test might reveal a high indoor spore count even though there is no visible evidence of mold. In this can, the inspection alone would not detect a mold problem even though one exists.

2. Conversely, a visual inspection may turn up evidence of surface mold even though an air test might show spore counts well within a normal range. In this case, the air test alone would not reveal a mold problem even though one exists.

The combination of a visual inspection and an air test is optimal for assessing mold conditions since one typically points to the other.

VISUAL INSPECTION EXPLAINED:

An inspection is a visual inspection of the property, inside and out, for evidence of mold and signs of water intrusion. The Visual Inspection reveals obvious molds on surfaces and helps determine hidden mold problems that may go unnoticed to an un-trained eye. A visual inspection can also uncover existing and potential moisture problems in construction materials. Wet or damp wood, drywall, and even concrete may not be a mold problem now, but will be if ignored. Airborne Environmental Consultants uses specialized electronic equipment to detect moisture levels of construction materials such as stucco, wood siding, plaster, drywall, cabinets, shower stalls and floors.

What is Mold?

Most people think that mold is slimy, blackish-green discoloration found on carpeting, baseboards or wallpaper that gradually increases in size, but found only in dirty, unkept homes or apartments. The truth is, mold and spores can flourish in sparkling clean environments as well.

Read more about Toxic Mold

Airborne Environmental Consultants

We are now offering a new service for anyone who wants limited information regarding moisture prevention  assessment ; mold assessment.

1. Visual inspection inside the house for moisture intrusion or mold.
2. Analytical tests in areas where mold samples are taken.  Humidity, temperature, and measurements..
3 First air sample with outdoors for comparison of air indoors.
4. If there are visible areas of suspected mold, we will take 2-3 tape lift from areas.

• Mold assessment report of finding; a management plan
• Management Plan
• Post Remediation Verification:
• Visual inspection with no air sample $200.00 to $350.00
• Cost per mileage $0.50 each way.

Pricing

Residential cost below
Commercial Property add $100.00   

Visual inspection with no air sample
$200.00 to $350.00 (up to 3,000 square feet)

Infared Moisture Inspection with Mold Inspection additional cost of $375.00

Infared Moisture Inspection with No Air Samples $500.00

Cost Per mile $0.50 each way.

1 HVAC unit:  3 air samples only-----$595.00;
-additional sample each -$125.00

2 HVAC units: 3 air samples only----$595.00;
-additional sample each -$125.00

3 HVAC units: 3 air samples only-----$595.00;
- additional sample each-$125.00

4. Greater than 12 Air-O-Cell , Tape, Swab samples will be quoted.

We believe that a limited survey of this nature will allow residential home owner’s , real estate agents, insurance adjustors , property managers, and lenders to identify if mold problem exists and whether a full investigation is warranted.

Investigation Includes

• Limited | Full Investigation

1. Inspection—inside, under pier beam, and HVAC inspection.
2. Moisture—testing in plumbing areas.( May requiere13-16 tests).
3. Analytical's in all mold sampling areas,(May include entire house).
4.Mold sample including baseline outdoors, services areas of each HVAC unit in damaged areas, wall checks in suspect  walls, sample of suspect materials such as carpeting, clothing, furniture and any other samples required.(May take as many as 35-40 samples).
5. Digital photos of damaged areas.
6. CAD drawing of property.
7. Analysis of all data gathered.
8. Written report which includes a mold assessment report.
9. Written a mold management plan for a facility or dwelling.
10. Written a mold remediation protocol.
11. Certificate of Mold Damage Remediation.
12. Licenses and Accreditation's.
13. AEC Consultants does not do any mold remediation or is affiliated with any remediation company. It is up to the customer to hire a specific contractor.
14. Payment is due when work is performed
15. Written Assessment Available in ten days or less

Price List 01/01/06